In order to keep your Can-Am Maverick X3 running smoothly, experts at Top Line Performance, an auto repair shop in Huntington Beach CA, recommend bringing it in for proper lubrication and maintenance service. Not only does your Maverick require greased wheel bearings, but you should also ensure that Heim joints, zerks, and driveshafts are lubricated with care. Plus, your Can-Am Maverick X3 requires the right kind of oil in order to perform at its highest capacity.
Oil Up at Auto Repair Shops in Huntington Beach
When you bring your Can-Am Maverick X3 into Topline Performance, you will receive quality care and service. Most mechanics recommend 10w40 grade oil for this vehicle but it can also run on Rotella T6 5w40, Mobil1 0w40, and Redline 5w40 Full Synthetic. Auto repair experts in Huntington Beach recommend changing your Maverick’s oil every 1,000 miles and getting routine maintenance to preserve its engine.
According to the owner’s manual, 75-90 front differential oil is adequate for the Can-Am Maverick X3. Our mechanics say that you might consider 75-140 oil for certain X3 editions such as the 2020 XMR Turbo RR. This oil will reflect well on your offroading adventures. As always, take note of any oil leaks from your vehicle and share this with your auto repair shop in Huntington Beach CA so that they can complete the necessary fixes.
Grease Up Your Can-Am Maverick X3
Every machine requires greasing now and then to ensure that the parts can run efficiently. With the Can-Am Maverick X3, the wheel bearings and zerks require regular lubrication. You can purchase your own grease tools for under fifty dollars or simply ask your local auto shop to do the job every so often.
In addition to zerks and wheel bearings, you should pay attention to CV joints, sway bar bushings, and Heim joints when your vehicle starts to sound creaky. This lubrication will help your Maverick sound better and run better. Certain aftermarket accessories may be purchased to help with noise control and can be installed by auto shop experts.
The Can-Am Maverick X3 has a slightly different driveshaft from other UTVs. That being said, you could run into some noises while offroading. If you are hoping to grease the driveshaft, then this requires a little more precision. You can mark the shaft points with a paint pen before unbolting the front shaft and pulling down the side panels. Once you see the carrier bearing, mark the shafts and rear and then unbolt it so that the driveshaft has forward mobility. Add a little tractor grease and put everything back!
Remember that cooling fluid and windshield wiper fluid are also important to replace in your Can-Am Maverick X3 to prevent things like overheating. So, when you’re checking off your list for greasing your vehicle, make sure to think of these solutions as well. You can bring your Can-Am Maverick X3 to Topline Performance to have our certified technicians perform regular inspections and maintenance service. Call us at (714) 477-7138 to schedule an appointment at our Huntington Beach shop.